72 Tele Deluxe Pick Guards

This pick guard is intended for Fender® 72 Tele® Deluxe Reissue style Guitars, Mexican or American made.

The following PDF file is intended for you to check the fit of this pick guard. It does not reflect every configuration available.
It is primarily intended for you to verify mounting holes and overall shape. Questions?

Fender® 72 Telecaster® Deluxe Reissue Pick Guard Outline PDF File

Configure it how you want here

Click through the links below the images for more details, options and prices.


T72D-WRHXWRH-1234TGL Original Configuration	T72D-BLNK Blank with Bevel	T72D-XXX-1234TGL No Pickups No Center Mount	T72D-H1XH1-1234TGL For Smaller H1 Humbuckers

T72D-H2XH2-1234TGL For Smaller H2 Humbuckers	T72D-H1XS1-1234TGL H1 Bridge Tele S1 Single at Neck	T72D-H2XS1-1234TGL H2 Bridge Tele S1 Single at Neck	T72D-H1XSRA-1234TGL H1 Bridge, Rev. Strat Single Coil Neck

T72D-H1XWRH-1234TGL H1 Bridge, WRH Neck

Wide Range Humbucker Adapter Rings

The following Pickup Ring Adaptors are for adapting a 72 Tele® Deluxe or Custom Wide Range Humbucker slot to any number of pickup
configurations. What is listed below is just the beginning of what is possible The following group is intended to utilize new mounting
holes to mount the new pickup ring. These holes will require drilling into the pick guard below and may penetrate the body if the cavity
route below is not large enough. The red line illustrates the original Wide Range Humbucker position.

Any of the following may still require additional modification to your pick guard or guitar.


	PRA-B-H1	PRA-B-H2	PRA-B-H3	PRA-B-MH1	PRA-B-S1	PRA-B-S	PRA-B-SRA

Save $20.00 when you buy a set of 7
any combination is ok

These are also available without mounting holes so you can utilize the existing Wide Range Pickup mount holes
to drill holes that match into these pickup adapter rings. You can also get these adapter rings with an adhesive
backing to avoid screws altogether.

I can drill the holes for mounting to existing Wide Range Pickup mounting holes but based on experience I would
guess the holes are somewhat inconsistent depending on who made the pick guard. If you order a pick guard I
cut and you want the adapter rings for your configuration options then I can drill matching holes and provide
mounting hardware as well.

Custom Positioning at no extra charge on acrylic parts
Specify in Special Instructions